Safety Instructions For Batteries - Silvercrest Z31498 Bedienungshinweise Und Sicherheitshinweise

FOOD SAFE! This product does
not affect the taste and aroma
properties of foodstuffs.
Safety Instructions
for Batteries
R emove the batteries from the device if they are
not going to be used for a prolonged period.
CAUTION! DANGER OF
EXPLOSION! The batteries must
never be recharged!
W hen inserting the batteries, ensure the correct
polarity! This is shown in the battery compart-
ments.
I f necessary, clean the batteries and device
contacts before inserting the batteries.
R emove spent batteries immediately from the
device. There is an increased danger of leaks!
B atteries must not be disposed of in the normal
domestic waste!
E very consumer is legally obliged to dispose of
batteries in the proper manner!
K eep batteries away from children; do not
throw them in the fire, short-circuit them or take
them apart.
I f the above instructions are not complied with,
the batteries may discharge themselves beyond
their end voltage. There is then a danger of
leaking. If the batteries have leaked inside your
device, you should remove them immediately in
order to prevent damage to the device!
A void contact with the skin, eyes and mucous
membranes. If you come into contact with
corrosive battery fluids, flush the affected area
thoroughly with clean water and contact a doctor
immediately.
Use
Insert Batteries / Filling of the
salt and pepper mill
Indication: The salt and pepper mill is intended
for peppercorns or coarse salt.
Proceed as follows:
1. Hold the base with the container
turn the top counter-clockwise (see Fig. A)
1
until the arrow on the top
the symbol on the base with container
2. Open the bayonet cap by turning and then
pulling it. The remove the top part
base with container
6
3. Pull the motor carefully off the base with
3
container .
6
4. Insert 6 new batteries type AAA 1.5 V
(LR03).
Indication: Pay attention to the right polarity.
This is shown in the battery compartment.
5. Fill up the base with container
corns or coarse salt. The best result will be
achieved when filling the base with container
up to 75 %.
6. Put the motor back on the base with contai-
3
ner . Be sure to place the notch on the motor
6
marked with a white arrow into the respective
protrusion on the base with container (see Fig.B).
Indication: Please make sure that the con-
tacts , face each other (see fig. A).
4 5
7. Put the top back on the base with con-
1
tainer .
6
8. Hold the base with container
turn the top clockwise (see Fig. B) until the
1
arrow on the top aligns with the symbol
1
on the base with container
Using of the salt
and pepper mill
P ull off the aroma seal cover
tom of the base with container
(see fig. B).
P lease keep the switch
the salt and pepper mill. The bulb
base of the salt and pepper mill will then be
simultaneously activated.
firmly and
6
is aligned with
1
.
6
from the
1
.
with pepper-
6
6
firmly and
6
.
6
from the bot-
7
before use
6
pushed to activate
2
on the
9
GB/IE 5