Safety Instructions For Batteries - Silvercrest Z30987 Bedienungshinweise Und Sicherheitshinweise

FOOD SAFE! This product does
not affect the taste and aroma
properties of foodstuffs.
Safety Instructions
for Batteries
Remove the batteries from the device if they are
not going to be used for a prolonged period.
CAUTION! DANGER OF
EXPLOSION! The batteries must
never be recharged!
When inserting the batteries, ensure the correct
polarity! This is shown in the battery compart-
ments.
If necessary, clean the batteries and device
contacts before inserting the batteries.
Remove spent batteries immediately from the
device. There is an increased danger of leaks!
Batteries must not be disposed of in the normal
domestic waste!
Every consumer is legally obliged to dispose of
batteries in the proper manner!
Keep batteries away from children; do not
throw them in the fire, short-circuit them or take
them apart.
If the above instructions are not complied with,
the batteries may discharge themselves beyond
their end voltage. There is then a danger of
leaking. If the batteries have leaked inside your
device, you should remove them immediately in
order to prevent damage to the device!
Avoid contact with the skin, eyes and mucous
membranes. If you come into contact with
corrosive battery fluids, flush the affected area
thoroughly with clean water and contact a doctor
immediately.
Use
Insert Batteries / Filling of the
salt and pepper mill
Indication: The salt and pepper mill is intended
for peppercorns or coarse salt.
78286 CB3 content.indd 5
Proceed as follows:
1. Hold the base with container
turn the top in a clockwise direction (see
1
Figure A) until the arrow on the top
with the on the base with container
2. Open the bayonet cap by turning and then
pulling it. The remove the top part
base with container
6
3. Pull the motor carefully off the base with
3
container .
6
4. Pull the battery ring
7
5. Insert 6 new batteries type AAA 1.5 V
(LR03).
Indication: Pay attention to the right polarity.
This is shown in the battery compartment.
6. Place the battery ring
motor .
3
7. Fill up the base with container
corns or coarse salt. The best result will be
achieved when filling the base with container
up to 75 %.
8. Place the motor back on to the base with
3
container and close the bayonet cap by
6
pressing it down and then turning it (see Fig. B).
Indication: Please make sure that the con-
tacts , face each other (see fig. A).
4 5
9. Put the top back on the base with con-
1
tainer .
6
10. Hold the base with container
the top in an anticlockwise direction (see
1
fig. B) until the arrow on the top
with the on the base with container
Using of the salt
and pepper mill
Pull off the aroma seal cover
tom of the base with container
(see fig. B).
Please keep the switch
the salt and pepper mill. The bulb
base of the salt and pepper mill will then be
simultaneously activated.
firmly and
6
is aligned
1
.
6
from the
1
.
off the motor .
3
back on to the
7
with pepper-
6
6
firmly and turn
6
is aligned
1
.
6
from the bot-
11
before use
6
pushed to activate
2
on the
9
GB/IE 5
7/23/2012 2:40:14 PM