Waeco MagicWatch MWE850 Montage- Und Bedienungsanleitung Seite 39

MWE-850-4DSM.book Seite 39 Mittwoch, 23. Mai 2007 4:35 16
MagicWatch MWE850
The sensor is preset to have a vertical installation angle of
approximately +5°. This means that the cover ring is thicker at the bot-
tom.
Note that the sensors must be aligned in a particular direction. The top of
the sensor is marked with a ▼ (see fig. 12.1, page 6).
Fit the sensors at regular intervals along the total width of the vehicle in
order to guarantee the optimum monitoring.
The sensors may be painted. WAECO recommends having the sensors
painted by a specialist workshop.
The installation procedure is as follows:
➤ Choose an installation location on the bumper which is as perpendicular
to the road surface as possible (see fig. 12, page 6).
When fitting the sensors, make sure that the coupling of the sup-
ply line can be reached outside the hole. This ensures that if you
have to replace the sensors you do not have to take off the bum-
per (fig. 20, page 9).
If the sensor cable is not long enough, you can order one-metre extension
cables (MWCS-1) as accessories.
Caution!
Before making any drill holes, ensure that no electrical cables or
other parts of the vehicle can be damaged by drilling, sawing and
filing.
➤ For each sensor, drill a hole in the bumper with a diameter of 22.5 mm
(22.5 mm core bit supplied).
➤ For a more accurate fit, slant the drill downwards slightly when drilling the
hole on the inside of the bumper. The sensor cover can now be easily
inserted at a downward angle.
➤ Guide the cables of the sensors through the corresponding hole.
➤ Insert each sensor into the corresponding drill hole until it latches into
place.
Installing MWE850
39