Waeco MagicWatch MWE850 Montage- Und Bedienungsanleitung Seite 37

MWE-850-4DSM.book Seite 37 Mittwoch, 23. Mai 2007 4:35 16
MagicWatch MWE850
Example 4 (see fig. 9, page 6)
In this case, MWE850 displays the distance A. As the vehicle approaches the
audible indicator goes over to the stop zone, and as it approaches further, the
distance A goes into the blind spot, so that MAGIC WATCH signals the dis-
tance from point B.
Caution!
As these four examples show, situations can arise where the
device fails to display an object or does not display the shortest
distance.
The device does not relieve you of your obligation to take special
care when reversing. Therefore, always be extremely careful
when reversing.
If an object enters the blind spot of the sensors, MWE850 automat-
ically shows the distance to the next object. This means the piezo-
electronic speaker changes from fast to medium beeps and the dis-
play shows a different distance.
In this case, always stop the vehicle immediately and check the sit-
uation.
The DSM function ensures that objects attached to the vehicle (such as
trailer couplings) are not classified as obstacles. As a rule they do not pro-
trude more than 0.3 m over the sensors. They are therefore in the close area
(zone 3) of up to 0.3 m, in which MWE850 gives a stop warning and where
you should stop (see the "Testing functions" on page 44 section).
Caution!
If loads or objects on the vehicle protrude over the close area of 0.3
m, there is a danger of accidents. An obstacle can collide with the
load or the object before it is detected by the sensors in the close
area and MWE850 gives a stop warning (see fig. 11, page 6).
Technical description
37