Operation; Internal Programs - Cameo CLBARL10RGBIR / WH Bedienungsanleitung

OPERATION:

INTERNAL PROGRAMS

Press the MODE button repeatedly until one of the 13 internal programs
appears on the display (PGxx):
PG00 PROGRAM COLOUR MACROS + STROBE
Using the UP and DOWN buttons, select the PG00 program. To change the
colour, press ENTER and select one of the seven available colours or blackout
by using the UP and DOWN buttons.
C- -0 = Blackout (LEDs off)
C- -1 = Red
C- -2 = Green
C- -3 = Blue
C- -4 = Cyan
C- -5 = Yellow
C- -6 = Magenta
C- -7 = White
Confirm with ENTER. The display now shows "FSxx". Now you can use the
UP and DOWN buttons to add a strobe effect to the previously selected colour.
"FS00" stands for stroboscope effect disabled, "FS01" for the slowest and
"FS99" for the fastest flash frequency. Once the desired stroboscope effect
has been set, press ENTER to confirm the input.
PG01 - PG12 COLOUR CHANGE PROGRAMS + STROBE
Using the UP and DOWN buttons, select one of the 12 colour changing
programs PG01 - PG12.
In the programs PG01 - PG12 different colours (red, green, blue, cyan, yellow,
magenta, white) are activated in turn with each other. The individual colours
can spread over the entire width of the LED bar, or be displayed in the 3
LED sections of the LED bar. The colour change occurs abruptly, and the
colours are blended into each other. The speed of the programs is separately
adjustable and a stroboscope effect can also be activated.
Adjusting the speed and the stroboscope:
Once you have selected one of the 12 programs, press ENTER to confirm. At
the same time, the display changes to "SPxx" (Speed). Now you can adjust
the speed as desired by using the UP and DOWN buttons (SP01 = slowest,
SP99 = fastest speed).
8