Music Control; Slave Mode - Cameo CLBARL10RGBIR / WH Bedienungsanleitung

OPERATION:
In order to both confirm and activate the strobe effect, press ENTER again
and the display will change to "FSxx". Using the UP and DOWN buttons, you
can now set the stroboscope speed (FS00 = strobe disabled FS01 = slowest
and FS99 = fastest flash frequency). Once the desired stroboscope effect has
been set, press ENTER to confirm the input.
AUTO MODE
Press the MODE button repeatedly until "AUTO" appears on the display. This
mode combines the internal colour change programs, that is, the programs
PG01 to PG12 are automatically activated in sequence.

MUSIC CONTROL

Press the MODE button repeatedly until "SUxx" appears on the display. Now
the LED projector is controlled by the built-in microphone and follows the
beat of the music (bass pulses). Use the UP and DOWN buttons to select the
sensitivity of the microphone (setting "SO00" = lowest, "SO31" = highest
microphone sensitivity).

SLAVE MODE

Press the MODE button repeatedly until "SLA" appears in the display. Connect
the slave and the master unit (same model) with a DMX cable. DMX OUT,
Slave: DMX IN). Now the slave unit follows the master unit.
SELECTING DMX MODE
Press the MODE button repeatedly until one of the five DMX modes appears
on the display (2CH, 3CH1, 3CH2, 9CH, 12CH). Press ENTER and use the UP
and DOWN buttons to select the desired DMX mode. Confirm with ENTER.
You will find tables with the channels of the different DMX modes on the
following pages of this manual.
DMX START ADDRESS
Press the MODE button repeatedly until "A" and 3 additional digits appear
on the display. Press ENTER to use the UP and DOWN buttons to select the
desired DMX start address (A001 - A512). Confirm with ENTER.
9