Connections, Controls And Indicators - Cameo CLBARL10RGBIR / WH Bedienungsanleitung

CONNECTIONS, CONTROLS AND INDICATORS:

1
1
IEC POWER SOCKET WITH INTEGRAL FUSE HOLDER
Power cord included. Always make certain that the operating voltage of the CAMEO LED projector (printed on
the rear panel) matches the mains voltage in your region
IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same type and rating. If the fuse blows
repeatedly, please contact an authorised service centre.
2
DMX INPUT
Male, 3-pole XLR socket. Used for connection to a DMX mixer or other DMX controllers. The connection is
made using a DMX cable.
3
EYELET FOR SAFETY CABLE
Overhead installation may only be carried out by trained personnel. The projector must be secured with an
appropriate safety cable to prevent falling.
4
FOUR DIGIT LED DISPLAY WITH 4 CONTROL BUTTONS
Operating instructions on the following pages.
5
DMX OUTPUT
Female, 3-pole XLR socket. Used to loop through the DMX signal to additional DMX devices.
6
IEC POWER OUTPUT SOCKET
Used to supply power to additional CAMEO projectors. Make sure that the total current consumption in
amperes (A) of all connected devices does not exceed the specified value on the device.
2
3
4
5
6
7 7