Electric Connections - V2 JET650 Bedienungsanleitung

1 Mechanical safety rib (CMS)
2 Opening command to connect VRD (data input)
Opening command to connect traditional
3
devices having normally open contact
4 Stop command. Normally closed contact
5 - 8 - 11 Common (-)
6 Photocell. Normally closed contact
+24VDC 10W photocell (RX) power supply and
7
other accessories
9 +24VDC 10W blinker
Compulsory TX photocells power supply +24VDC
10
1W for check test
12 +24VDC 3W Pilot light
13 - 14 Power supply
15 Antenna gearbox
16 Antenna hearth brade
17 YELLOW: position sensor (level zero)
18 BLACK: position sensor (level zero)
19 RED: position sensor (level zero)
20 GREEN - 24VDC motor output
21 BROWN - 24VDC motor output
22 - 23 - 24 ENCODER
L1 Courtesy lamp model E14
CAUTION: UNUSED INPUTS THAT ARE NORMALLY
CLOSED (CMS, STOP , PHOTOCELL) SHOULD BE CONNECTED TO
THE COMMON WIRE (-).

ELECTRIC CONNECTIONS

Carefully read the paragraph "IMPORTANT WARNING" at the
previous page.
• Open the guard by turning at 90° the push-button P1.
• As far as the connections are concerned, please see the
paragraph "CONNECTIONS TO TERMINAL BOARD", fixing the
cable output as the illustration explains.
• Once the connections have been carried out, close the guard
and turn the push-button to its original position.
27