Problem Solving - V2 JET650 Bedienungsanleitung

SYMPTOMS
The door movement is irregular
The start RADIO input doesn't move the
door
The start input from KEYBUTTON doesn't
move the door
The courtesy light blinks quickly for 5 s
after any start command and the door
DOESN'T move
The automatic functioning logic doesn't
work

PROBLEM SOLVING

PROBABLE CAUSE
The door is not properly balanced
The truck meets points with more frictions
during its run on the guide
The current sensor level doesn't fit the
door weight
The transmitter is not properly set
The connection to the terminal board is
not correct
The connection to the terminal board of
Normally Closed inputs (safety rib, stop
and photocell) is not correct
The photocell connection is not correct
The photocells are not connected or
connection is not correct
32
REMEDY
Release the door (see paragraph
RELEASE FROM INSIDE) and balance the
door properly
Release the door, separate the truck from
the bracket linked to the door and move
the truck along the whole guide to locate
the friction points. Remove the frictions
working on the joints of the section and
remove any twisting or deformation.
Set the current sensor level and if
necessary switch off slowing down.
Check the proper antenna connection,
totally erase the transmitter codes and
restart the procedure of STORING OF A
TRANSMITTER BYMEANSE OF P1 KEY.
The radio card could be damaged: call V2
Technical Assistance Dept.
Check the proper connection to the
external start key: if P1 key activates the
automation, the problem is given to the
wiring of the external key.
Check the connection and correct the
errors.
Check the connection of the photocells
and if necessary disable the check test
(see paragraph PRE-FLASHING AND
PHOTOCELL TEST)
Check the photocell connection and
restart the AUTOMATIC LEARNING phase