Electrical Connections; Encoder Connection; Emergency Unblocking - V2 VULCAN Serie Bedienungsanleitung

ELECTRICAL CONNECTIONS

VULCAN-230V / VULCAN-120V
Motor cable
YELLOW - GREEN
GREY
BLACK
BROWN
m
WARNING: Always connect the earth cable to the
mains power earth system. Use the special fastom shown in
the figure, and a cable with a minimum cross sectional area
of 2.5 mm
2
VULCAN-24V
Motor cable
BLUE
BROWN
SX

ENCODER CONNECTION

To connect the encoders please refer to the control unit manual.
m
WARNING: For the encoders to work properly it is
essential that the stoppers inside the case are installed
correctly.
m
ATTENTION: DO NOT use the motor cable channel for
the sensor cables.
m
ATTENTION: extensions of the cables must be made
only with a 4x0,22 shielded cable with polyethylene sheath
m
ATTENTION: connect the shielding braith sheath to the
common accessories. Check that the ground of the power
supply of the accessories is connected to the common
accessories.
Downloaded from www.Manualslib.com
CONTROL UNIT
DX motor SX motor
GND GND
COMMON COMMON
OPENING CLOSING
CLOSING OPENING
CONTROL UNIT
DX motor SX motor
+ -
- +
manuals search engine

EMERGENCY UNBLOCKING

In the case of a power failure, the gate can be unblocked
mechanically by operating the motor.
Insert the supplied unblocking lever and rotate 180° clockwise.
Automation will be automatically restored the first time the motor
is operated.
- 12 -
DX