Final Closing Thrust Force; Rolling Code Mode; Key Start Function; Courtesy Light And Blinker - V2 JET650 Bedienungsanleitung

FINAL CLOSING THRUST FORCE

To set the final closing thrust force proceed as follows:
1. Press and keep pressed P1 key for 5s (courtesy light on) and
at the same time transmit with keys 3 and 4 of the
transmitter (transmission must last at least 3 s)
2. When the courtesy light switch off, stop the transmission
and release P1 key.
3. After 2 sec. the courtesy light visualizes the setted level with
the relative number of flashes. SEE CHART.
4. The courtesy light switch off for 2 sec. Then it goes on again
for 5 sec. waiting for a transmission.
5. Transmit (within 5sec) with the ideal key according to the
CHART.
6. The courtesy light switch off for 2 sec and therefore it
visualizes the new level setted with the relative number of
flashes. SEE CHART.
TX KEY FLASHING N° DESCRIPTION
Key 1 1
Key 2 2
To correct any one of the parameters, restart from point 1.

ROLLING CODE MODE

It is possible to activate or disable the ROLLING CODE mode.
Its activation makes any attempt of code duplication
impossible. To activate the "rolling code" function it is
necessary to act on the jumper J1 on the printed circuit:
J1 open = ROLLING CODE mode activated
J1 closed = ROLLING CODE mode not activated

KEY START FUNCTION

Press key P1 which is on the card and give a "start" command,
it must be kept pressed for less than 5 seconds in order to
avoid the radio-learning activation.

COURTESY LIGHT AND BLINKER

During the opening-closing phase, the courtesy lamp is switched
on and stays on for 1,5 minutes from the end of the cycle or
from the last command.
Tasto 3 + 4
+
5 sec.
Final closing thrust force OFF
Final closing thrust force ON

NEW TRANSMITTER RADIO LEARNING

• Press at the same time the push-buttons 1 +2 or 1+3 of a
transmitter which has been already stored and keep them
pressed for 10 seconds, then release them as soon as the
courtesy lamp blinks once.
• Transmit the desired code within 5 seconds.
• The courtesy lamp blinks once to show that the storage has
been performed, then it remains switched on for 5 seconds
waiting for a new transmission.
• After 5 seconds, the light will be switched off and the
control unit will quit the self-learning phase.

TOTAL ERASING OF TRANSMITTER CODES

• Disconnect the control unit.
• Press and keep P1 self-learning external push-button
pressed.
• Power the control unit at the same time, the courtesy light
will switch on and stays on until the key P1 is pressed.
• Release the key P1: the courtesy light will switch off:
the control unit is ready to use.

ERROR SIGNALS

The error signals are visualized by some flashings of the
courtesy light:
FLASHINGS (5 sec.)
• During the transmitters storing: the memory is full.
• During the normally functioning: photocells error or damage.
FLASHINGS (10 sec.)
• During the automatic learning: cicle interruption by the key P1.
• During the normally functioning: encoder error or damage.

SERVICE

The control unit provides for the "SERVICE" signal, which tells
the final user that it has already performed 5000 working
cycles. Such a signal will be repeated during the following 10
working cycles as to the cycle nr. 5000 and it means that the
warning light, the courtesy lamp and the blinker will stay
switched on for 10 seconds (that is to say: without blinking).
Such signalling occurs after a valid command, starting the
operation cycle. Such signal will be repeated each 5000
working cycles.
31