Overview.of.functions; Installing.the.control.unit - Becker S55 Bedienungsanleitung

Operating Instructions
Function
Setting.mode.(up/down.in.dead-man.mode)
Maintain.in.ascending.direction
Maintain.in.descending.direction
Anti-pull-in.cable.safety
Slack.rope.switch.debounced
Button.input:.UP/STOP/DOWN/STOP
Automatic.closing
Partial.opening
Pneumatic.safety.edge
Electrical.safety.edge
Safety.edge.switchover:.1..kOhm/8..kOhm
Optoelectronic.safety.edge:.FRABA.OSE
Photoelectric.barrier
Yard.light
Traffic.lights/door.status.indicator
Warning.lamp
LED.for.power.supply.
LED.UP.direction
LED.DOWN.direction
LED.Operating.status
LED.ERROR
LED.Safety.edge
LED.for.special.function
Voltage.output.(4.V.DC./.00.mA)
.Operates.only.when.a.safety.edge.is.used
1)
) .Function.optional.when.using.the.Module.Card
Install.the.control.unit.so.that.the.operator.controls.are.readily.accessible..The.cover.of.the.housing.with.the.3-way.pushbutton.
switch.has.to.be.removed.for.installation.purposes.
The.unit.is.mounted.on.the.wall.with.four.4.mm.∅.screws.(max..head.dia..8.mm).using.the.four.fastening.holes,.which.also.take.
the.screws.to.fit.the.cover,.in.accordance.with.the.dimensioned.drawing.on.the.bottom.of.the.housing.
If.necessary,.you.can.fit.more.cable.glands.for.sensor.cables.and.indicating.cables.
Attention
When removing housing knockouts in order to fit more cable glands, take care not to damage any compo-
nents on the control boards or the housing itself. Only fit sealing cable glands which ensure the housing
has the correct degree of protection.
When refitting the cover, ensure that the seal and the seal groove are clean and that the cover is mounted
properly.
Tighten up the housing cover screws carefully. Only then will the IP 54 degree of housing protection re-
main intact.

Overview of functions
Installing the control unit
ELS Professional Card
X
X
.X 1)
X
X
X
..X
)
..X
)
X
X
X
X
X
..X
)
..X )
..X
)
X
X
X
X
X
X
X
..X
)