Cebora Sound MIG 3540/T Star Pulse Betriebsanleitung Seite 13

O
C
D
E
B
A
a microswitch. Low pressure is indicated by the abbrevi-
ation H2O flashing on the display AM.
3.2.2 Fuse (T 2A/250V - Ø 5x20).
This fuse is inserted to protect the motor pump, and is
located on the rear panel of the welding machine H.
3.2.3 Positioninng on sloping planes.
Since this welding machine is equipped with wheels with-
out brake, make sure the machine is not positioned on
sloping planes, to avoid tilting or noncontrolled motion of
the machine itself.
4 DESCRIPTION OF CONTROL PANEL (Fig. 2)
AE selection key.
Each brief pressure selects the size, adjustable via the AI
knob. The values that may be selected are in relation to
the type of welding process selected, and are displayed
on the LEDs AA/AB/AC/AD.
LED AA PRG.
Indicates that the display AL shows the set program
number. Active only in MIG processes.
LED AB Thickness.
TheAL display shows the recommended thickness
based on the set current and wire speed. Active only in
synergic MIG processes.
N
M
F
L
I
H
G
Fig. 1
LED AC Wire speed.
Indicates that the display AL shows the wire speed in
welding. Active only in MIG processes.
LED AD Current.
Indicates that the display AL shows a welding current.
During welding always shows the measured current;
with the machine at a standstill, if AG is OFF, shows the
set current.
LED AF - Globular position.
May not be selected. Active in synergic MIG process.
When lit, this signals that the pair of values chosen for
welding may give unstable arcs and splatters.
LED AG - Hold.
May not be selected. It activates in MIG, MMA and TIG
welding and it signals that the values shown on the dis-
plays AL and AM (normally Amperes and Volts) are those
used during last welding. Activated at the end of each
welding session.
LED AH - Voltage.
In all MIG welding processes, it indicates that the display
AM shows the re-set welding voltage or, if in combination
with LED AG
In MMA and TIG welding processes is always ON and
may not be selected. Ii indicates that the display AM,
shows the open-circuit voltage or, if in combination with
LED AG lit, the actual welding voltage.
lit, the last measured
O
P
voltage.
13