Hitachi RAS-3FSVNE Betriebshandbuch Seite 12

5
REMOTE CONTROLLER OPERATION
4
5. REMOTE CONTROLLER OPERATION
5.1. OPTIONAL LIQUID CRYSTAL REMOTE CONTROL PC-P1HE
Model: PC-P1HE - (PC-2H2)

Fan Speed Indicator
It indicates the fan speed you have selected:
High / Medium / Low
Total Ventilator Indicator
It indicates if Total Ventilator have been selected.
- A/C only air conditioning.
- VENTI only ventilation.
- A/C + VENTI when both have been selected.

Operation Mode Indicator
Indicates the operation mode selected:
Fan, Cool, Heat, Dry, Auto (Cool/Heat)

Run Indicator (Red Lamp)

RUN/STOP Switch

MODE (Operation Mode Selection) Switch

FAN SPEED (Fan Speed Selection) Switch

Up & Down Panel Operation Switch
(Not Available)

VENTI (Ventilator Operation) Switch

LOUVER (Swing Louver Operation) Switch

TIME (Time Setting) Switch
Increases and decreases the Set Time for timer
operation

ON/OFF TIMER Switch
Used to activate or deactivate the timer operation

CHECK Switch

RESET (Filter Reset Switch)
After cleaning the air filter, press the "RESET" button.
The filter indication

cleaning time is reset. It also stops the Alarm indication
procedure.

TEMP (Temperature Setting) Switch

T.RUN (Test Run Indication)
Check (Check Indication)
These Tests appears when "TEST RUN" or "CHECK"
is being performed

ABNML (Alarm) Indicator
"FILTER" Indicator

SET TEMP (Set Temperature) Indicator

ON/OFF Timer (Timer Operation Indicator)
Alarm Code Indicator
"NO FUNCTION" Indicator

CENTRAL (Central Control Indicator)
Indicates that central station or CS-Net is being
performed

Swing Louver Indicator
"DEFROST" Indicator
When opening the cover,
pull the cover toward the arrow direction
NOTE:
− Do not use this system as constant temperature and
constant humidity control equipment.
− In the case that the LOW fan speed is selected and
outdoor temperature is higher than 21°C, excessive
load is given to the compressor at heating operation.
Therefore, set the fan speed at HIGH or MEDIUM,
since safety devices may be activated.
− When the system is started after a shutdown longer
than approximately 3 months, it is recommended to
check the system by your service contractor.
− Turn OFF the main switch when the system is stopped
for a long period of time.
− If the main switch is not turned OFF, electricity is
consumed, because the oil heater is always energized
during compressor stopping.
will disappear and the next filter