Programming Buttons For Generic Or Coded Actuator; Programming For Intercom Call; Programming/Deleting Intercom Address (Selective Intercom Only); Tab B Selective Intercom Addresses - Comelit 8472MB Technisches Handbuch

DIP S2
DIP 1 DIP 2 DIP 3 DIP 4
0 0 0 0
1 0 0 0
0 1 0 0
1 1 0 0
0 0 1 0
1 0 1 0
0 1 1 0
1 1 1 0
0 0 0 1
1 0 0 1
0 1 0 1
1 1 0 1
0 0 1 1
1 0 1 1
0 1 1 1
1 1 1 1
Example:
on a monitor with user code 5, P1 programming = generic actuator, P2 =
coded actuator (code 125).
1. Set S2 DIP switch 5-6 to the combination 01.
» the LED (green) fl ashes.
2. Refer to the table on page 26 and select a combination in which the
actuator function (ACT) is listed for the buttons you wish to program.
E.g.: for P1= generic actuator, set S2 DIP switches 1-2-3-4 to the
combination 1000 or 1100 or 0010 (P1=ACT), set S1 DIP switches to the
combination 11111111, go to point 3.
E.g.: for P2= coded actuator (code 125), set S2 DIP switches 1-2-3-4
to the combination 0010 or 1010 (P2=ACT), set S1 with address 125 in
accordance with table C on page 28, go to point 3.
General and selective intercoms CANNOT be used together on the same riser.
1)
S1
Programming; set code, TAB. B on page 26
DIP ON
Cancellation
Take note of the S2, S1 setting and restore it when programming is complete.
Codice / Code Dip switch ON
1 1
2 2
3 3
You must set the intercom address on all the riser's internal units.
You can assign the same intercom address to a maximum of 3 internal units.
For group calls, select the desired intercom codes simultaneously (max. 3).
26 26

Programming buttons for generic or coded actuator

A
P1 P2
ACT
A
ACT
ACT ACT ACT
ACT
A

Programming for intercom call

Programming/deleting intercom address (selective intercom only)

DIP DIP DIP
1 2
0 0
1 1

TAB B Selective intercom addresses

S1 Codice / Code Dip switch ON
4
5
6
with Art. 6433, 6434
P3 P4
ACT
ACT
ACT ACT
ACT
ACT
PROG
3. Press and release the button to be associated with the function.
» the LED (green) lights up.
» confi rmation tone in handset.
4. To exit programming mode, set S2 DIP switches 5-6 to the combination 00.
» the LED (green) switches off.
5. When programming is complete, set S2 DIP switches 1-2-3-4 to the
combination 1111. Restore the user code setting on S1, see table
A on page 24.
2)
DIP DIP DIP
S2
3 4 5 6
0 1 1 1
1 1 1 1
S1
4
5
6
P5 P6
ACT ACT
ADDRESS
ACT
3)
Codice / Code Dip switch ON
7 7
8 8
DIP S1
2 sec
S1