Hartmann Tensoval mobil Gebrauchsanleitung Seite 39

The Comfort Air Technology auto-
matically determines the systolic
blood pressure value and thus the
individual inflation pressure for
blood pressure measurement. If this
inflation pressure is insufficient or if
the measurement is interrupted, the
device continues to pump at a rate
of 40 mmHg until a high enough
pressure is reached. Once the
required inflation pressure has been
reached, a short beep signals that
the measurement starts.
If you require a higher inflation
pressure, you can avoid having to
repeat pumping by pressing the
blue START/STOP button again
shortly after inflation starts and
holding down on it until the desired
cuff pressure is reached. This
should be approx. 30 mmHg over
the systolic (upper) value.
Important: You should
not move or talk throughout
the entire measuring procedure! If
you wish to stop measurement for
any reason, simply press the blue
START/STOP button. The inflation or
measuring procedure is interrupted
and an automatic fall in pressure
occurs.
As pressure in the cuff decreases,
the heart symbol and the falling
cuff pressure are displayed. A long
beep indicates the end of measure-
ment. Then the systolic and dias-
tolic blood pressure values appear
simultaneously on the display, with
the pulse rate beneath them (see
fig.):
Once the measurement is finished,
the time appears above the meas-
ured values and M1 or M2 is dis-
played on the left. M1 represents
41
English