Cleaning And Maintenance; A) General; Changing The Crystal - Reely ROAD Titan Bedienungsanleitung


12.

Cleaning and maintenance

a) General information
Prior to cleaning or servicing, turn the vehicle off and completely separate the rechargeable battery pack
from the drive control. If you have driven the vehicle beforehand, let all parts (e.g. engine, drive control,
etc.) cool down completely first.
Clean the whole vehicle of dust and dirt after driving, use e.g. a long-haired clean brush and a vacuum cleaner.
Compressed air aerosols can also be helpful.
Do not use cleaning aerosols or conventional household cleaners. This may damage the electronics and
lead to discolouration on the plastic parts or the body.
A soft, slightly dampened cloth can be used to wipe the car body. Do not rub too firmly to avoid scratch marks.
At certain intervals, perform maintenance work and function controls on the vehicle. This ensures trouble-free operation
and roadworthiness for a long time.
Motor vibrations and shocks during driving can loosen parts and screw fittings. This is why you should always check
the tightness of wheel nuts and all screws before and after using the model. The same applies for other parts of the
vehicle.
Check if the tires fit correctly on the wheel rims or whether the adhesions have come undone.
If worn out or defective vehicle parts must be replaced, use original spare parts only.
Make sure that no cables are pinched or bent.
Check the model for damage before each use! If you notice any damages, the vehicle must not be used anymore and
has to be taken out of operation.
b) Changing the crystal
There must be no other transmitters/models using the same frequency in the range of the remote control, as they
interfere with each other. As a result, the models no longer respond properly to the remote commands. If there are
other model vehicles in your range, talk to the other operators about the frequencies they use.
For reasons of operational safety, you should only use crystals that are explicitly recommended for the use
of your remote control system by the supplier.
• Before changing a crystal, first turn off the vehicle and then the remote control.
• Pull the holder of the transmitter crystal out of the transmitter casing (see figure 1, pos. 6).
• Take the transmitter crystal out of its plastic holder. Insert the replacement crystal with a different channel in the
same frequency band.
Please make sure that you place the right crystal in the holder. Transmitter crystals are normally marked with the
letter T or TX (T = "transmitter").
36