Herunterladen Inhalt Inhalt Diese Seite drucken

J) Ending Drive; K) Carrying The Vehicle - Reely ROAD Hotlander Bedienungsanleitung

1:10 ep truck brushless 4wd rtr
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

j) Stopping Drive
To stop the drive, proceed as follows:
• Let the vehicle roll to a halt.
• Once the vehicle is stationary, pick the car body up and put the on/off switch on the vehicle in the "OFF" position.
Make sure not to touch the wheels or the drive, and do not move, in any case, the lever for the drive
function on the remote control!
• Disconnect the drive battery from the cruise control. Unscrew the plug-in connection completely.
• It is only now that the transmitter might be turned off.
Attention!
The motor, drive control and accumulator pack become very hot during operation! Do not touch these
parts immediately after operation. Danger of burns!
Stop driving straight away when you notice unusual responses of the vehicle to the control commands
on the transmitter or when the vehicle no longer responds.
This behaviour could be caused by a weak vehicle battery, weak batteries/rechargeable batteries in the
remote control or by too high a distance between vehicle and remote control.
An antenna that was not pulled out all the way, disturbances on the radio channel used (e.g. other
models, radio transmissions through other devices) or adverse transmission/reception conditions could
also be a cause for unusual responses of the vehicle.

k) Carrying the vehicle

For simple, secure and comfortable transport the vehicle is
provided with a carrying strap (1) that is mounted on the
rear.
This allows you to carry the model with two fingers only
without reaching into the drive or damaging the thin car body
during carrying.
Figure 6
33

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis