Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning And Maintenance; A) General Information - Reely ROAD Hotlander Bedienungsanleitung

1:10 ep truck brushless 4wd rtr
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen



10. Cleaning and maintenance

a) General information

Prior to cleaning or servicing, turn the vehicle off and completely separate the accumulator pack from
the drive control. If you drive the vehicle beforehand, leave all parts (e.g. engine, drive control, etc.) cool
down completely at first.
Clean the whole vehicle of dust and dirt after driving, use e.g. a long-haired clean brush and a vacuum cleaner.
Compressed air aerosols can also be helpful.
Do not use cleaning aerosols or conventional household cleaners. This may damage the electronics
and lead to discolouration on the plastic parts or the body.
A soft cloth, slightly dampened can be used to wipe the car body. Don't rub too hard otherwise there will be scratch
marks or the paint will get damaged.
At certain intervals maintenance works and function controls that ensure trouble-free operation and roadworthiness
for a long time, are to be carried out on the vehicle.
Motor vibrations and shocks during driving can loosen parts and screw fittings. This is why you should check the tight
position of wheel nuts and all screw fittings. The same applies for other parts of the vehicle.
Check if the tires sit correctly on the wheel rims and if the adhesions loosened.
All ball bearings or gears in the vehicle have been provided with suitable lubricants by the manufacturer. Normally no
relubrication is necessary. However, the joints on the vehicle and the wheel bearings require occasional cleaning and
relubrication with suitable lubricants (available in accessory shops). The same applies when replacing drive parts or
gears.
It is imperative that you remove excessive oil or fat since this is where dust settles particularly quickly
again.
If worn out or defective parts must be replaced, use original spare parts only to replace them. You can order them
through our customer service.
Make sure that no cables are pinched or caught.
Check the model for damage before each use! If you notice any damages, the car must not be used anymore and has
to be taken out of operation.
36

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis