♦
Push the detent pin
in the clamping flange (inside)
detent pin
in this position . If necessary, rotate
the cutting disc
by hand until this is possible .
♦
Use the hex key supplied (large)
the fixing nut
out in an anticlockwise direc-
tion .
♦
Remove the plane washer
flange (outside)
♦
Insert a new cutting disc .
♦
Proceed in reverse order in order to reassemble
the appliance to a usable condition .
♦
Check whether all the fastening elements are
correctly fitted .
NOTE
►
Ensure that the cutting disc
freely .
►
Switch the appliance on for around 60
seconds to check that there are no unusual
vibrations . If this is not the case, you should
check that the cutting disc is installed
correctly
.
Clamping the workpiece
You can clamp the workpiece and adjust the mitre
angle with the aid of the fitted vice .
Using the vice
♦
Turn the handle on the vice
clamp the workpiece .
♦
Turn the handle on the vice
unclamp the workpiece .
NOTE
►
You can also fold the rapid adjustment
upwards in order to make a quick adjustment
to the vice
. Fold the rapid adjustment
down again in order to fix the vice
this, use the vice
adjustments .
Setting the cutting angle (mitre angle)
♦
Loosen the cutting angle adjustment
turning it anticlockwise .
■
10
│
GB │ IE │ NI
into the U-shaped recess
and hold the
to unscrew
, the clamping
and the cutting disc
can be rotated
clockwise to
anticlockwise to
. After
handle to make fine
by
♦
Set the required cutting angle using the angle
given .
♦
Retighten the cutting angle adjustment
turning it clockwise .
Cleaning and maintenance
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
.
wall socket before carrying out any work on
the appliance.
■
The appliance must always be kept clean, dry
and free from oil or grease .
■
Use a soft, dry cloth to clean the housing .
■
Clean the ventilation slits in your power tool
with a soft brush regularly .
NOTE
►
Replacement parts not listed (such as carbon
brushes, switch) can be ordered via our
service hotline .
►
Required maintenance work should only be
replaced by qualified service personnel .
by
PMTS 180 A1