Warnings Specific To The Air Angle Grinder - Parkside 6.3 A2 Bedienungs- Und Sicherheitshinweise

Safety instructions for ... / Warnings specific to the air angle grinder
check that the hoses and their
fasteners are undamaged and
have not detached.
Locking pins must be used
„
on universal swivel (jaw)
couplings. Whipcheck hose
fasteners must be used as
protection against a failing
hose–machine and hose–hose
connector.
Make sure that the maximum
„
pressure specified on the ma-
chine is not exceeded.
Never carry pneumatic ma-
„
chines by their hoses.
Use the device only for appli-
„
cations it has been designed
for!
Do not overload the device.
„
Never use bottled hydro-
gen, oxygen, carbon
dioxide, or other gases as an
energy source: these can cause
explosions and therefore serious
injury.
DANGER! Keep your
hands and limbs away
from rotating parts. Otherwise,
there is danger of injury.
Make sure that the motor oil
„
SAE 10-20 is applied correctly
for the optimal lubrication of
the pneumatic device (see Sec-
tion "Operation" on page 16).
Contact with eyes or skin can
cause inflammation or irrita-
tion. It is therefore important
that the motor oil is applied
with great care into the com-
pressed air connection on the
pneumatic devices.
z Warnings specific to the
air angle grinder
Before fitting a parting disc,
„
after every tool repair, and
before the first use of an angle
grinder, always check the
speed dial and make sure that
the angle grinder's actual idle
speed at 6.3 bar does not
exceed the speed stamped or
printed on the type plate. Fur-
thermore, all angle grinders in
use must be examined at least
once a shift.
Make sure that the parting
„
disc has been fitted correctly
and the parting disc nut tight-
ened securely. The parting disc
should not sit too tightly or too
loosely.
Check that the speed specified
„
on the parting disc is at least
equal to the rated speed of the
pneumatic angle grinder.
Otherwise, accessories turning
GB 15