Introduction; Intended Use; Features; Package Contents - Parkside PMTS 180 A1 Originalbetriebsanleitung

METAL CUT-OFF GRINDER
PMTS 180 A1

Introduction

Congratulations on the purchase of your new appli-
ance . You have chosen a high-quality product . The
operating instructions are part of this product . They
contain important information about safety, usage
and disposal . Before using the product, please
familiarise yourself with all operating and safety
instructions . Use the product only as described and
for the range of applications specified . Please also
pass these operating instructions on to any future
owner .

Intended use

The cut-off grinder is intended as a floor-mounted
appliance for making straight longitudinal cuts at
up to 45° using cutting discs in steel, nonferrous
metals, cast iron and iron profiles without the use
of water .
Any other uses of or modifications to the machine
are deemed to be improper usage and may result
in serious physical injury .
Not for commercial use .
■ 2 │ GB │ IE │ NI

Features

ON/OFF switch
Clamping flange (inside)
Locking pin
Cutting disc
Rapid adjustment
Vice
Drillholes
Cutting angle adjustment
Transport safety device
Cutting depth adjustment
Motor unit
Handle
Figure A:
Pendulum cover
Protective cover
Integrated carrying handle
14a
Mounting screws
Figure B:
Clamping flange (outside)
Plain washer
Fixing nut
Figure C:
Hex key (large)
Hex key (small)

Package contents

1 metal cut-off grinder PMTS 180 A1
1 cutting disc Ø 180 mm (pre-fitted)
2 Hex keys
1 set of operating instructions

Technical data

Rated voltage:
Rated power consumption: 1280 W
Rated idle speed:
Cutting disc mounting:
Thread size:
Maximum speed
of the cutting disc:
230 V ∼, 50 Hz
(alternating current)
n 7700 rpm
0
ø 22 .23 mm
M8
8500 rpm
PMTS 180 A1