Parkside PMTS 180 A1 Originalbetriebsanleitung Seite 11

■ Observe the operating manual published by
the cutting disc manufacturer when fitting and
using the cutting disc. Unsuitable cutting disks
can lead to personal injury and may cause
snagging, tearing of the disc or kickback .
■ Do not use any accessories that have not been
specifically provided or recommended by the
manufacturer for this power tool. Just because
you can attach the accessories to your power
tool does not guarantee they are safe to use .
■ Do not touch the cutting disks after work until
they have cooled down. Cutting discs become
very hot while they are working .
■ Check the cable regularly. Damaged cables
may only be repaired by an authorised
customer service location for power tools.
Replace any damaged extension cables . This
will ensure that the safety of the power tool is
maintained .
■ Store unused power tools safely. The storage
location must be dry and lockable. This pre-
vents the power tool being damaged by stor-
age or being used by inexperienced persons .
■ Secure the workpiece! A workpiece securely
held by a clamping device or vice is much safer
than one held in your hand .
■
Never leave the tool until it has come to a
complete standstill. Power tools which continue
to run on can cause injuries .
■ Do not use the power tool with a damaged
cable. Never touch a damaged cable and
remove the plug from the mains socket if the
cable becomes damaged during work. Dam-
aged cables increase the risk of electric shock .
Supplementary notes:
■ Always wear eye and ear protectors . Use other
protective equipment such as dust masks, pro-
tective gloves, protective goggles if necessary .
■ Never use any cutting discs with spalling, cracks
or other damage .
■ Always visually inspect cutting discs before
each use .
■ Do not use any saw blades .
■ Never use the appliance without the disc guard .
■ 8 │ GB │ IE │ NI
WARNING! DANGER DUE TO DUST
EXPOSURE!
► When working for extended periods of time
on wood and, in particular, materials that
produce dust which is hazardous to health,
connect the appliance to an appropriate
external dust extraction appliance .
Symbols used on the power tool:
Keep your hands clear of the cut-
ting area while the power tool is
running. There is a danger of injury
if you contact the cutting disc .
Wear protective gloves!
Wear a dust mask!
Wear protective goggles!
Wear hearing protection!
Wear safety shoes!
Not designed for wet grinding
Use of
damaged cutting or
polishing discs is
dangerous and can lead to
serious injuries!
Intended for metal grinding
Disc diameter
80
Before using the device for
the first time, read the original
operating instructions and safety
instructions .
PMTS 180 A1