Heyner MultiProtect Comfort Bedienungsanleitung Seite 9

English
2. Adjusting the HEYNER MultiProtect to your child's size
2.1. Preparation (fig. 1a-c)
®
The HEYNER HEYNER
MultiProtect Comfort has its own belt system (D), the harness belts, which needs to
be adjusted to your child's size as follows:
®
Place the HEYNER HEYNER
MultiProtect Comfort on a normal chair and set your child in it. To ensure
optimum positioning of the belts, make sure that the shoulder belts (D) run down from just above the
child's shoulders (fig. 1c), not too high above them (fig. 1a) and not too low (fig. 1b). Don't leave your
child unattended in the seat.
2.2. Height and length adjustment of the shoulder belts (fig. 2a-c)
Height adjustment of the shoulder belts (harness belts, D):
Release the belt ends from the belt anchorage point (K) at the back of the seat (fig. 2a) and pull both
belt ends out of the slots (J1 or J2 or J3). Put the belt ends through the belt slots (J1 or J2 or J3) that
are appropriate to the child's size. Finally, thread the belt ends back into the belt anchorage point
(K).
To release (fig. 2b) the shoulder belts (D), push the metal belt adjuster (H), hidden by the cover, and
pull both harness belts simultaneously forward.
To shorten (fig. 2c) the shoulder belts (D), just pull the belt end element (I). Do not block the
shoulder belts during pulling.
Attention: It is recommended to check the belt position very regularly and to
adjust it to the size of your growing child. The belts must lie firmly against
the child's body and must not be twisted.
www.heyner-germany.de
13
2.3. Adjusting the head rest to the child's size (fig. 2d)
In order to adjust the height of the head rest to your child's size push the seat down on the
vehicles seat to keep it there. With the other hand de-block the head rest de-block lever (M) on
the back of the head rest by pulling it backwards at the same time. Keep the lever de-blocked
and pull the head rest simultaneously up or down, according to the child's size. Relase the lever.
The head rest needs to be fixed in one of the guide wholes with an audible sound. Please check
by pulling on the head rest, if it does not move anymore without pulling the lever. The middle of
the head rest needs to be exactly at the height of the middle of the child's head to have the
highest side protection effect.
3. Installing the HEYNER MultiProtect into your car
3.1. Conditions for installation (fig. 3)
®
The HEYNER HEYNER
MultiProtect Comfort may be placed on all passenger seats of the vehicle that
are equipped with a three-point-vehicle-belt. The child seat must not be positioned on a vehicle
seat, which only has a lap belt, example given the centre back seat of cars with three seats in
the back.
3.2. Placing on the vehicle seat (fig. 4)
®
Now put the HEYNER HEYNER
MultiProtect Comfort onto the car seat in driving direction.
www.heyner-germany.de
English
GB
HEYNER
14