Heyner MultiProtect Comfort Bedienungsanleitung Seite 8

English
Index / page
GROUP I (about 9 to 18 kg) Y/
®
1. Using the HEYNER HEYNER
MultiProtect Comfort as a child car seat
®
2. Adjusting the HEYNER HEYNER
MultiProtect Comfort to your child's size
®
3. Installing the HEYNER HEYNER
MultiProtect Comfort into your car
®
4. Securing the child into the HEYNER HEYNER
MultiProtect Comfort
5. Fixing the belt clip
GROUP II (about 15 to 25 kg)/
®
Using HEYNER HEYNER
MultiProtect Comfort without harness belts
GROUP III (about 26 to 36 kg) /
®
1. Changing the HEYNER HEYNER
MultiProtect Comfort into a booster seat
2. Using as a booster seat
Care instructions /
Important notices
A Backrest J1 for children up to 2 years (children about
B Side belt guide 9 - 15 kg)
C Belt channel K Belt anchorage point
D Harness belts / shoulder belts L Fixation lugs for three-point-vehicle-belt
E Buckle latches M Head rest de-block lever
F Belt buckle N Diagonal belt of the three-point-vehicle-belt
G Booster O Lap belt of the three-point-vehicle-belt
H Belt adjuster P Buckle latch of the three-point-vehicle-belt
I Belt end element Q Belt buckle of the three-point-vehicle-belt
J Shoulder belt slots R Connecting hooks
J3 for children up to 6 years (children about S Connecting holes
26 - 36 kg) T Belt block anchor
J2 for children up to 4½ years (children Z Belt clip
about 15 - 25 kg)
www.heyner-germany.de
11
GROUP I (about 9 to 18 kg) Y
HEYNER ® MultiProtect Comfort as a child car seat
1. Using the HEYNER
S. 12
S. 13
S. 14
®
You have purchased the HEYNER HEYNER
MultiProtect Comfort car seat for your child. We thank you
S. 16
for your trust. Please note, that the optimum safety characteristics can only be achieved, if the
S. 16
seat is used properly according to instructions. Therefore we ask you to ensure the correct
installation of the seat in your vehicle by reading the operating instructions carefully. Please
S. 17
keep instructions always with the seat for further information.
Only to be assembled by adults!
S. 19
S. 19
Connecting the back rest to the booster seat (fig. 19)
(just if non-assembled)
S. 20
If backrest (A) and booster (G) are delivered in a non-assembled way, please follow these
instructions to connect both together before using it for children in group I and II:
Lay down the booster on the floor and the back rest flat right behind. Than thread the
connecting hooks (R) on the bottom of the backrest into the fitting holes (S) on the back of the
booster with a firm downwards motion. Now bring the back rest slowly upright, 90° to the
booster. The connecting hooks should now slip into the fitting holes with an audible sound. As a
result the backrest should be well fixed to the booster in the upright position. It must not slip
away now. Otherwise you may not have fixed it very well an using it would be dangerous. In this
case please repeat the first steps of this part of the instruction.
www.heyner-germany.de
English
GB
HEYNER
HEYNER
12