PeakTech 4980 Bedienungsanleitung Seite 29

HIGH (HAL) / LOW (LAL)- Alarm
Press the up button or down button to turn HAL/LAL on or off. Press
the
Measurement Trigger to confirm the High/Low alarm mode.
After switching on or off the HAL/LAL, press the SET-key to switch to
the
alarm- value setting.
Use the UP or DOWN-key to set the desired value for HAL or LAL.
When HAL or LAL is activated the backlight will flash in red color and
A warning noise will sound.
This unit is equipped with a visual alarm.
If during a measurement, the measured temperature exceeds the
preset "high alert" temperature, the backlight will flash with red LED.
The same behavior shows the device when the measured
temperature is lower than the preset "low alarm" temperature.
"High Alert" resp. "Low Alarm" to preset and must be enabled.
EMS adjustment
LOCK on/off
HAL on/off
HAL adjustment
LOW on/off
LOW adjustment
-28-