Mounting Preparation - Sanotechnik H30W Montageanleitung

ENGLISH – ENGLISH – ENGLISH – ENGLISH – ENGLISH – ENGLISH - EN

Mounting Preparation

1. After opening the case, read this introduction carefully, check all the packed parts, examine the shower cabinet for
shipping damage. If there is any problem, please contact the local seller or our company directly in time. You will get a
satisfactory answer.
2. Necessary tools: drilling machine, stone drill (∅=6mm), crosstip screwdriver, water-level, meter stick, pencil.
3. With structured or imprinted glass make sure that the smooth side of the glass faces the inner side.
4. It is installed each shower cubicle work-page for test purposes, connects, tests and packs again.
5. The douche cup positions and by means of adjustable feet, puts in a way, that no water remains in the douche cup.
RESPECT: necessarily test. Later complaints are impossible.
6. The montage can become implemented only through authoritarian compartment companies (for example plumber),
otherwise the guarantee goes out. see also hint for connection of water and stream,
7. It is the enclosed construction instruction to be paused, as well as all parts must be sealed with sanitary silicone
(silicone denseness test) additionally against each other. All screws, tube clamps, etc. its solidity and denseness is
checked. Something been able to relax through the transportation.
Mounting
1. Set scales-quite geared up the shower tray (10). Install the drain pipe.
2. You connect the fixed glass walls (4) and the bent rails (7). You use screws for it.
3. You give the sliding doors (6) into the bent rails (8). you use screws for fixing about the sliding doors.
4. You fix the grip poles (3) with the screws. Then place the profiles (2) into the profiles of the fixed glass walls (4) the
waterproof aluminium.
5. You bandage the side panel (18) with the main panel (15). you use screws for it. you please make the same on
which of the mirrors with the panel is.
6. You put the entire panel, 3 panels together, on the douche cup (10). you use screws for the joining.
7. You give the top (16) at the shower. Bandage this screws.
8. You put the whole cubicle on the shower tray (10). Then use screws to connect with the douche cup about the
panels.
Page 2