Adjusting The Printouts - Sony UP-D70XR Gebrauchsanweisung

Adjusting the Printouts

24
Operation
You can adjust the picture quality of a printout with the MENU button before
printing. The most recent setting remains effective until changed.
Note
The next printout will be printed with the values newly set by the following
procedure. You cannot adjust the setting during printing.
1
Press the MENU button.
Note
If you do not press any button for approximately 15 seconds after pressing the
MENU button , the printer is automatically reset to standby status.
2
Display the COLOR ADJUST menu by pressing the ◊ or √ button.
The first item of the printout adjust menu (for RED) appears in the printer
window display. The default or preset level is shown both as a value and
graphically.
RED :
_ _ _ _ _ _ _ _ _ _ _ _ _ _
3
Perform ajdustment.
1 Select the item for adjustment by using the ◊ or √ button.
√ : Scrolls up to the previous item.
◊ : Scrolls down to the next item.
2 Adjust the level by pressing the ı or ∫ button.
You can adjust the level for RED, GREEN and BLUE of the color, DARK
and LIGHT of the tone and GAMMA of the half tone between –32 to +32.
The center of the graph and the value 0 is the standard level.
∫ Increases the level.
ı : Decreases the level.
The sharpness can be adjusted among 4 levels: NONE /LOW/MIDDLE/
HIGH.
1, 4 2, 3
0
Default level (or preset level)