Eliwell EWCFW-08 Bedienungsanleitung Seite 83

Model: Current (A) / Voltage (V)
(1)
Power (kVA)
Rated output current (A)
Maximum output current (A)
Power supply
Rated input current (A)
Switching frequency (kHz)
(5)
Maximum motor power
Dynamic braking
Internal Category C2 RFI filter
(optional)
External Category C1 RFI filter
(optional)
Watt loss (W)
Dimensions in mm [in]
(Height x Width x Depth)
Table 7.2 b) - Technical information about the inverter models
CHAPTER 7 - TECHNICAL SPECIFICATIONS
13/ 16/
380-480 380-480
9.9 12.2
(2)
13 16
(3)
19.5 24
15 19
5 5
7.5 HP / 10 HP /
5.6 kW 7.5 kW
Yes Yes
Yes Yes
Yes Yes
218 268
203 x 143 x 165
[7.99 x 5.63 x 6.5]
13-16-24-30 A/380-480 V
NOTE!
(1) The power rating in kVA is determined by the following
equation:
3 . Voltage (Volt) . Current (Amp)
P(kVA) =
The values shown in the table were calculated by considering the
rated inverter current, input voltage of 220 V for the 200-240 V
models and input voltage of 440 V for the 380-480 V models.
(2) Rated current is valid for the following conditions:
Relative air humidity: 5 % to 90 %, non condensing.
Altitude: 1000 m (3280.8 ft), up to 4000 m (13123.3 ft) with
10 % derating/1000 m (3280.8 ft) of the rated current.
Ambient temperature: 0 ºC to 40 ºC (32 ºF to 104 ºF) (up to
50 ºC (122 ºF) with 2 %/ºC derating of the rated current).
The rated current values are valid for the switching
frequencies of 2.5 kHz or 5 kHz (factory setting). For higher
switching frequencies, 10 kHz and 15 kHz, consider the
values shown in the description of the parameter P297.
(3) Maximum output current:
Inverter supports an overload of 50 % (maximum output
current = 1.5 x the rated output current) during 1 minute for
each 10 minutes of operation. For higher switching
frequencies, 10 kHz and 15 kHz, consider 1.5 times the
values shown at the description of the parameter P297.
24/ 30/
380-480 380-480
18.3 24
24 30
36 45
Three- phase
28.8 36
5 5
15 HP/ 20 HP/
11 kW 15 kW
Yes Yes
Yes Yes
Yes Yes
403 500
290 x 182 x 196
[11.42 x 7.16 x 7.72]
1000
83