Eliwell EWCFW-08 Bedienungsanleitung Seite 10

CFW-08 - QUICK PARAMETER REFERENCE
Parameter Function
P236 Analog Input AI1 Offset
(6)
P238 Analog Input AI2 Gain
(3)(5)(6)
P239 Analog Input AI2 Function
(6)
P240 Analog Input AI2 Offset
P248 Analog Inputs Filter
Time Constant
Analog Output
(6)
P251 Analog Output
AO Function
(6)
P252 Analog Output AO Gain
P253 Analog Output AO Signal
Digital Inputs
(3)
P263 Digital Input DI1 Function
(3)
P264 Digital Input DI2 Function
(3) (7)
P265 Digital Input DI3 Function
(**) Only available on the control board A2 (refer to item 2.4). For programming instructions, please, refer to the parameter P235 detailed
description.
10
Adjustable Range
-999 to +999
0.00 to 9.99
0 = (0 to 10) V/(0 to 20) mA/
(**)
(-10 to +10) V
1 = (4 to 20) mA
2 = DI6 PNP
3 = DI6 NPN
4 = DI6 TTL
5 = PTC
-999 to +999
0 to 200
0 = Output Frequency (Fs)
1 = Input Reference (Fe)
2 = Output Current (Is)
3, 5, 8 = Not Used
4 = Motor Torque
6 = Process Variable (PID)
7 = Active Current
9 = PID Setpoint
0.00 to 9.99
0 = (0 to 10) V/(0 to 20) mA
1 = (4 to 20) mA
0 = No Function or General
Enable
1 to 7 and 10 to 12 =
General Enable
8 = Forward Run
9 = Start/Stop
13 = FWD Run Using
Ramp 2
14 = On
0 = Forward/Reverse
1 = Local/Remote
2 to 6 and 9 to 12 = Not Used
7 = Multispeed (MS2)
8 = Reverse
13 = REV Run - Ramp 2
14 = Off
0 = Forward/Reverse
1 = Local/Remote
2 = General Enable
3 = JOG
4 = No External Fault
5 = Increase E.P.
6 = Ramp 2
7 = Multispeed (MS1)
8 = No Function or
Start/Stop
9 = Start/Stop
10 = Reset
Factory User
Unit
Setting Setting
0.0 %
1.00 -
0 -
0.0 %
10 ms
0 -
1.00 -
0 -
0 -
0 -
10 -
Page