Eliwell EWCFW-08 Bedienungsanleitung Seite 30

CHAPTER 3 - INSTALLATION AND CONNECTION
3.1.3 Positioning and Fixing
30
When installing the CFW-08, free space around the inverter
must be left as indicated in figure 3.2. Table 3.2 shows the
required free spaces.
Install the inverter in vertical position according to the following
recommendations:
1) Install the inverter on a flat surface.
2) Do not install heat sensitive components immediately above
the inverter.
ATTENTION!
When inverters are installed side by side, maintain the
minimum recommended distance B.
When inverters are installed top and bottom, maintain the
minimum recommended distance A + C and deflect the hot
air coming from the inverter below.
ATTENTION!
Provide independent conduits for signal, control and power
conductors separation (refer to item 3.2 - Electrical Installation).
Use separate conduits or trunking for control and power wiring
(see item 3.2 - Electrical Installation).
Figure 3.2 - Free spaces for cooling