Eliwell EWCFW-08 Bedienungsanleitung Seite 71

CHAPTER 4 - KEYPAD (HMI) OPERATION
NOTE!
(1) For parameters that can be changed with the motor running,
the inverter will use the new value immediately after it has
been set. For parameters that can be changed only with
motor stopped, the inverter will use this new value only after
the key is pressed.
(2) By pressing the
new programmed value will be stored automatically and
will remain stored until a new value is programmed.
(3) If the last programmed value in the parameter is not
functionally compatible with other parameter values already
programmed, E24 = Programming Error, will be displayed.
Example of programming error:
Programming of two digital inputs (DI) with the same
function. Refer to table 4.1 for list of programming errors
that can generate an E24 Programming Error.
(4) To allow the reprogramming of any parameter value (except
for P000 and P121) it is required to set P000 = 5.
Otherwise you can only read the parameter values, but not
reprogram them.
key after the reprogramming, the
71