Reely Titan Bedienungsanleitung Seite 52

• Function #5, green LED flashes 1x long: Maximum braking strength
The speed controller unit provides proportional braking strength depending on the setting of the throttle/brake lever
on the transmitter. The maximum braking power at full lever extension can be adjusted to 25%, 50%, 75% and
100%.
A high setting (e.g. 100%) decreases braking distance but has a negative effect on the lifetime of the gear (drive
pinion gear, main gear and differential gears).
• Function #6: green LED flashes 1x long and 1x short: Max. reverse speed
The maximum speed for reversing can be programmed with this function. Settable values are 25%, 50%, 75% und
100%. We recommend setting the reverse speed to 50% so that the vehicle can be controlled better in reverse
driving.
If reverse driving has been switched off (see "Function #1"), this setting has no effect.
• Function #7: green LED flashes 1x long, 2x short: Minimum braking strength
This is where you can set the braking strength when the braking process begins (depending on the setting of the
transmitter throttle/braking lever).
The preset is the same braking strength as the motor brake function (see "Function #2"), but values of 20% and 40%
can also be programmed so that the vehicle slows/stops more quickly.
• Function #8, green LED flashes 1x long, 3x short: Neutral range (for neutral setting on transmitter)
This function allows the range or area "D" (see picture right) is recognised
as the neutral position by the transmitter. For the "D" area, the values of
6%, 9% and 12% of the lever travel can be set.
The picture of the transmitter on the right serves only for illustration and
does not necessarily correspond to the design of the transmitter provided.
A = Mechanic centre position of the throttle/brake lever (neutral position)
B = Full throttle forwards
C = Full throttle reverse
D = Neutral range
E = Forwards range
F = Reverse range
• Function #9, green LED flashes 1x long, 4x short: Timing
Generally, higher values for timing increase the engine speed. Torque, however, decreases and power consumption
increases (lower driving time, engine and controller may overheat). The manufacturer has already chosen the best
settings for the engine built into the vehicle. It should only be changed by experienced model sportsmen.
Settable values are 0.00, 3.75, 7.50, 11.25, 15.00, 18.75, 22.50 and 26.25.
52
A
D
E
B
Figure 10
C
F