Maintenance And Service; Maintenance And Cleaning - CST/BERGER Theodolite DGT 2 Originalbetriebsanleitung

Troubleshooting
The chart show possible errors and their cause(s).
Press the respective button to correct the error.
Display Cause
Indica-
tions
E01 The measuring tool was
turned too quickly during a
horizontal measurement.
E02 The telescope was turned too
quickly during a vertical meas-
urement.
E03 Error during a vertical angle
measurement.
When the error message is
still indicated after a restart,
please refer to an authorised
service agent for Bosch
power tools.
E04 Error during a horizontal angle
measurement.
When the error message is
still indicated after a restart,
please refer to an authorised
service agent for Bosch
power tools.
E06 Error while setting the vertical
zero point.
Refer to an authorised service
agent for Bosch power tools.
26 | English

Maintenance and Service

Maintenance and Cleaning

Keep the measuring tool clean at all times.
Correc-
Do not immerse the measuring tool in water or other
tive
fluids.
Measure
Wipe off debris using a moist and soft cloth. Do not
use any cleaning agents or solvents.
OSET
Take care not to scratch the lens during cleaning.
Only use a soft brush or a soft cloth.
V / %
If the measuring tool should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an authorised after-sales
2 x
service centre for Bosch power tools. Do not open the
measuring tool yourself.
Transport
When storing or transporting, always switch
the display off.
Use the original case to protect the measuring tool
2 x
during transport.
As far as possible, do not transport the measuring tool
when mounted to a tripod.
Should this however be necessary, hold the measur-
ing tool as vertical as possible, carry it in front of your-
self and never horizontally over the shoulder.
2 610 A15 111 • 23.6.09