Technical Data - Rothenberger PIPECUT TURBO 400 Bedienungsanleitung

2

Technical data

MODEL
Voltage
Power
No-load speed
Blade diameter
Mounting bore
Weight 250/400
Range of use D 250/400
Max. pipe wall steel
Max. pipe wall plastics
Protection calss
The noise level during the work may exceed 85 dB (A). Use hearing protection devices!
Measurement values determined according to standard EN 60745-1:2010.
The values indicated are valid for the nominal voltages indicated in the table. For lower voltages and models
for specific countries, these values may vary.
Revise the item number on the specifications plate of the machine.
The trade name of each machine may be different.
Only for power tools without induced start-up current: the start-up cycles generate brief voltage drops. If the
mains power supply conditions in the system are not favourable, this could cause interference with other
equipment/systems. With system impedances below 0.36 ohm, breakdowns are likely.
Vibrations
Total vibration values (sum of triax vectors) set according to the standard UNE EN 60745.
The vibration emission level specified in this sheet was measured according to a standardised test specified
in the standard UNE EN 60745 and can be used to compare tools. It can be used for a preliminary evaluation
of the exposure.
The vibration emission level stated represents the main applications of the tool. Nevertheless, if you use
the tool for other applications, with different accessories or poor maintenance, the vibration level could be
different. This could significantly increase the level of exposure throughout the total working period.
!
Warning! An estimate of the level of exposure to vibrations must also take into
account the time that the tool will remain off or when it is on but not being used. This
could significantly reduce the level of exposure throughout the total working period.
Identify any additional safety measure to protect the operator from the effects of
vibrations, such as: good maintenance of the tool and the accessories, warm hands,
organisation of the working templates, etc.
PIPECUT TURBO 250/ 400
230V/50-60Hz 110V/50-60Hz
1600W
1000-4000r/min
140mm/165mm
62mm
8,3Kg/ 10,2Kg
20-250mm/80-400mm
8mm
20mm
回/II
ENGLISH
MODEL
Spindle lock
Speed preselection
Constant electronic control
Overload Protection
Reduced starting current
Vibration
LpA(sound pressure)
KpA(sound pressure uncertanity)
LWA(acoustic power)
KWA(acoustic power uncertanity)
PIPECUT TURBO 250/ 400
Yes
Yes
Yes
Yes
Yes
ah,AG=3.18m/s², k:1.5m/s²
96dB(A)
3dB
107dB(A)
3dB (A)
23