Safety Instructions; Technical Data - Rothenberger WALL CUT 6540 Bedienungsanleitung

e) Do not overreach. Keep proper footing and balance at all times. This enables better
control of the power tool in unexpected situations.
f) Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and
gloves away from moving parts. Loose clothes, jewellery or long hair can be caught in
moving parts.
g) If devices are provided for the connection of dust extraction and collection facilities,
ensure these are connected and properly used. Use of these devices can reduce dust re-
lated hazards.
4) Power tool use and care
a) Do not force the power tool. Use the correct power tool for your application. The cor-
rect power tool will do the job better and safer at the rate for which it was designed.
b) Do not use the power tool if the switch does not turn it on and off. Any power tool that
cannot be controlled with the switch is dangerous and must be repaired.
c) Disconnect the plug from the power source and/or the battery pack from the power
tool before making any adjustments, changing accessories, or storing power tools.
Such preventive safety measures reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of the reach of children and do not allow persons unfamil-
iar with the power tool or these instructions to operate the power tool. Power tools are
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage
of parts and any other condition that may affect the power tools operation. If dam-
aged, have the power tool repaired before use. Many accidents are caused by poorly
maintained power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these instruc-
tions, taking into account the working conditions and the work to be performed. Use
of the power tool for operations different from those intended could result in a hazardous sit-
uation.
5) Service
Have your power tool serviced by a qualified repair person using only identical re-
placement parts. This will ensure that the safety of the power tool is maintained.
1.3

Safety Instructions

Please remove the plug from the socket before carrying out any work on the equipment!
Materials containing asbestos are not to be processed!
The equipment is only to be applied to the work piece when it is switched on! Never place your
hands in the cutting area of the cut-off wheels!
Always hold the equipment with both hands when working, thus ensuring a safe position. The
equipment must not be used without the additional handle and appropriate protective device!
Caution: Electric lines, gas and water pipes in the walls. Be sure to check for these lines and
pipes, e.g. using a metal detector!
Caution when cutting into supporting walls! Slits in supporting walls are subject to part 1 of
the DIN 1053 standard or country-specific regulations. These regulations are to be adhered to.
Please consult the responsible stress analyst, architect or competent site engineer before be-
ginning work. The depth and width of the slit depend on the wall thickness and the building ma-
terial used.
2

Technical Data

Voltage .......................................................... 230 V, 50/60 Hz
Capacity ........................................................ 2400 W
Rated speed .................................................. 6600 min
Cut-off wheel bore ......................................... 22.2 mm
12
-1
ENGLISH