6. Mounting and putting into operation
a) Mounting the lower cup
Do not fail to observe the instruction for mounting the smoke
detector in section 5.
• Remove the upper cup of the smoke detector by rotating the upper and lower
cups in opposite directions (counter clockwise) carefully. Fixed locking of
upper/ lower cups is possible only with batteries inserted!
1
• The lower cup can be screwed tightly by means of the two fastening holes
(1), e.g. to the wall or the room ceiling.
Depending on the base, two fastening holes are to be drilled previously and
suitable dowels inserted.
Pay attention when drilling/tightening the screws that no
power, gas or water pipes are damaged! Danger to life!
1 Holes for fastening
2 Latching nose
2
Figure 4
33