Harman Kardon AVR 70 Bedienungsanleitung Seite 6

AVR 700, AVR 70, AVR 70C
Video Recorders
Connect an analog video recorder's video input connector to the AVR's Video 1 Out
composite video connector and its audio input connectors to the AVR's Video 1 Out
analog audio connectors. You can record the Video 2 composite video input signal.
AVR Analog
Audio Connectors
AVR Composite
Video Connectors
Analog Audio/Video
Cable (not supplied)
Connect the Radio Antennas
• Connect the supplied FM antenna to the AVR's FM 75Ω antenna connector. For the best
reception, extend the FM antenna as far as possible.
• Bend and fold the base of the supplied AM antenna as shown and connect the antenna
wires to the AVR's AM and Gnd connectors. Rotate the antenna as necessary to minimize
background noise.
AVR
Antenna
Connectors
FM Antenna
(supplied)
AM Antenna
(supplied)
Connect to AC Power
Connect the AC power cord to the AVR's AC Input connector and then to a working AC power
outlet. IMPORTANT: Before connecting the AC power cord, make sure that the AC voltage listed
on the AVR's back panel matches the AC voltage used in your country.
AVR
AC Input
Connector
Power Cord
(supplied)
6
Install the Batteries in the Remote Control
Remove the remote control's battery cover, insert the three supplied AAA batteries as
shown in the illustration, and replace the battery cover.
To Analog
Audio/Video
Record Inputs
Analog Video
Recording Device
NOTE: Remove the protective plastic from the AVR's front panel to keep it from reducing
the remote control's effectiveness.
Turn On the AVR
1. Set the AVR's Main Power switch to "On." (The Standby indicator will glow amber.)
2. Press the front-panel On/Standby button.
Bend and fold base
AC Power
Outlet
Connections and Setup
Standby
Indicator
Power
Main Power
On/Standby
Switch
Button
Stereo Surr.Select