Technical Data; Transportation, Storage; Transport; Storage - Maico EZQ .. B series Montage- Und Betriebsanleitung

5. Technical data

For technical data, refer to the rating plate.
Degree of IP54* or IP 55*, depending
protection on unit variant
*
Protection only guaranteed in horizontal
installation position or, in the case of
vertical installation, with downward air flow.
Information
● Rating plate  fan  instructions
envelope.
● Dimensions and characteristic curves
 catalogue  Internet.
● Internet  maico-ventilatoren.com or
using the QR code on the fold-out page.

6. Transportation, storage

6.1 Transport

DANGER
Danger of injury: Unauthorised means of
transport or lifting gear may result in the
unit falling.
 Weight 4 to 34 kg, depending on type,
note technical data and centre of gravity
(centre).
 Observe the permitted maximum loading
capacity for lifting gear and means of
transport.
 Do not stand under a suspended load.
CAUTION
Risk of cuts from metal housing
plates with sharp edges.
 Wear protective gloves.
NOTICE
Risk of damage to unit if means of
transport are incorrectly attached.
Do not place load on sensitive components,
such as an impeller.
5. Technical data │ UK
Information
● Use suitable ropes or chains for transport.
● Maico accepts no indemnification or
warranty claims in the event of improper
transport.

6.2 Storage

● Only store fan horizontally in a suitable,
dry room: ambient temperature
- 10 to + 60 °C.
● Before installing, check that the motor
bearing is working properly.
● Maico accepts no liability for corrosion
damage caused by improper storage,
e.g. storage in a damp room.

7. Installation preparations

Always note the relevant specifica-
tions for electrical installations and
 when fitting equipment. In
Germany observe DIN VDE 0100
and  the corresponding parts in
particular.
Select installation site where foreign
bodies will not be accidentally drawn
in.
1. Fit a wall breakthrough and plaster the
breakthrough.
2. Make sure there is a level support surface
for the wall plate [7] or steel wall ring [8].
3. Lay a permanent power cable to the
installation location.
4. With free air intake or discharge, install a
protective grille SG in front of the device.
5. Ensure a sufficient fresh air supply intake.
17