Konica Minolta Multi Gloss 268 Betriebsanleitung Seite 46

Calibration and Autodiagnosis 14
Scale
You can use the Scale menu option
to switch back and forth between
Gloss Units and Reflectance (see
the Section on Practical measuring
suggestions). Move the mark to the
desired entry and press mode. A
check mark identifies the Scale that
is selected. After you switch the
Scale, the unit must not be
recalibrated.
Change cal.values
The gloss values of the calibration
standard in the holder included
with delivery are saved in the
measuring device. During
automatic calibration, this data is
assigned to the standard in the hol-
der.
In some cases it will be necessary
to enter data for a new calibration
standard, for example if the
previous standard has been
damaged or scratched.
To ensure exact calibration, only
original standards from the
manufacturer should be used.
You can use the path shown here
to the side to reach the Change
cal.values menu option.
45