Konica Minolta Multi Gloss 268 Betriebsanleitung Seite 45

14 Calibration and Autodiagnosis
44
time to allow the optical
components to adjust before
calibrating and using the unit.
You can use the path shown here
to the side to reach the Calibrate
menu option.
To begin calibration, press on the
scroll wheel.
The calibration process is
performed automatically for all
three geometries. The saved
calibration values of the standard
appear in the display.
The unit then switches into
Measurement mode (Mode).
State
This menu item provides you with
information on the calibration status
of the unit.
In particular, you can check here
whether the saved calibration
values match those of the holder.
The display also indicates if an
error message was generated as a
result of the last autodiagnosis or
calibration. If this has happened,
further information is available
under Section 21: Errors and
warning messages.