3. Setting up
3.1.
Safety Information
NOTE: Before setting up, it is essential that you read the General
Information at the beginning of this manual.
3.2.
Check contents of pack
The following items are supplied:
one base station
one handset with standard batteries
one telephone connecting cable
two screws
one headset
3.3.
Connecting the base station
1. Position the base station near to your
telephone connection socket and to a mains
socket. Insert the plug of the power supply
into the socket on the underside of the base
station and plug the power supply into a
properly installed 230 V mains socket. The plug-in power supply for
the base station must always be connected. For safety reasons, use
only the plug-in mains power supply provided.
2. Connect the telephone cable supplied to the
telephone socket and the telephone jack on
the underside of the base station. Use only
the new telephone cable provided.
3. Run the two cables through the clamps and
the two cable channels to the rear of the
base station.
- Setting up -
one mains power supply
one belt clip
one instruction manual
two wall plugs
59