Starting Up; Connecting The Base Station; Tone Or Pulse Dialling Mode - AUDIOLINE Oslo 282 Bedienungsanleitung

2

Starting Up

2.1 Safety information
Caution: It is essential to read the Safety Information in Chapter 1 before starting up.
2.2 Checking the contents of the package
The package contains:
a base station with power adapter plug
two handsets
a charging station with power adapter plug
2.3

Connecting the base station

Connect the base station as illustrated in the diagram. For reasons of safety, only use the
power adapter plug and telephone connection line supplied.
Plug the power adapter plug in a properly installed power outlet.
Mains power outlet
Telephone line socket
2.4 Connecting the charging station
Connect the charging station as illustrated
in the diagram. For reasons of safety, only
use the power adapter plug supplied.
2.5 Inserting the batteries
Insert two batteries of the type AAA Ni−MH 1.2 V 550 mAh
in the battery compartment after opening it. Pay attention
to correct polarity (refer to Fig.)! Close the battery compart-
ment cover.
Important: Do not use any other type of batteries.
2.6 Charging the batteries
When preparing to use the handset for the first time, place it in the base station (display facing up-
wards) for at least 14 hours. The charging control lamp on the base station lights up. The handset
warms up during the charging process. This is normal and does not represent a risk. Do not
charge the handset with charging units from other manufacturers. Failure to charge the batteries
properly can lead to telephone malfunction.
The current battery charge status is indicated in the display:
Full
2.7

Tone or Pulse dialling mode

The telephone can be connected to both analogue connections (pulse dialling) and digital con-
nections (tone dialling). The equipment is set to Tone dialling mode at the factory. If the telephone
does not work on your telephone connection, refer to Chapter 7.3 to learn how to switch the tele-
phone to analogue, pulse dialling mode.
2.8 Operating on private branch exchanges
If your telephone is connected to a private branch exchange, the R button can be used to imple-
ment the transfer calls or automatic callback functions. When used on a private branch exchange,
a Recall time of 100 ms must be set. The dealer where you purchased the exchange can provide
information as to whether the telephone will work properly with the exchange.
− Starting Up −
a telephone connection cable
four rechargeable batteries
an operating manual
Half empty
Mains power outlet
Low Empty
33