Wall Mounting; Handling And Operation; Setting The Movement Sensor - FLORABEST FTUS 3.6 A1 Originalbetriebsanleitung

CAUTION
GB
► Never set the device up without the earth spike
■ The supplied earth spike
use it with both components fi xed together, or only use one com-
ponent to achieve a lower height.
■ Insert the earth spike
■ In order to guarantee optimum movement detection, the device
must be located so that the movement sensor
direction of the area to be monitored.
■ The movement sensor

Wall mounting

♦ Drill a hole (ø 6 mm) and insert the wall plug
drilling, ensure that you do not inadvertently damage power, gas
or water lines.
♦ Screw the supplied screw
proximately 1 cm of the screw
then hang the device onto it.

Handling and operation

To start operating the device, please note the following points:

Setting the movement sensor

♦ Turn the sensitivity regulator on the movement sensor
The sensitivity of the movement sensor
range or size of the animals to be detected. The smaller the animal,
the higher the preset sensitivity on the movement sensor needs to
be (max.).
If a larger animal such as a dog is to be detected, turn the sensi-
tivity regulator on the movement detector
10
comes in two parts. You can either
into the fi xing for the earth spike
may not be blocked by other objects.
into the wall plug
is protruding from the wall and
depends on the distance,
!
.
is pointing in the
supplied. When
so that ap-
clockwise.
anticlockwise (min.).
FTUS 3.6 A1