How To Measure - Beurer BM 10 Gebrauchsanleitung

8. Description of display mark
Display mark Condition/Cause
Mark appears in the
measurement condition
when pulse is detected.
Replace Appears when the bat-
tery voltage is excessive-
batteries
ly low.
Measuring Appears when the accu-
rate blood pressure could
error
not be obtained accurate-
ly.
Inflation This symbol appears while the cuff is being inflated
Releasing
Mark appears in the measurement condition.
the air
Action
Measurements in pro-
gress remain quiet.
Replace batteries with new
ones. Insert the batteries at
correct positions beware of
the +/- directions.
Press "start/stop" button
again and re-measure. Or
check cuff if wrapped at
the upperarm or according
to instructions. Check palm
if exerting effort. Check if
talking or moving during
measurement. Check if
posture is incorrect.

9. How to measure

A. Inserting batteries in position:
a Open battery cover.
b Refer to the picture in positioning batteries. (Figure No.
3)
c All LCD segments appear on the display in 3 seconds.
d Display 1 month, 1 date, 12 hour, 0 minute.
B. Setting Date and Time:
a Press MODE button ("month" starts flashing).
Press SET button to set the correct month (1,2,3,...12).
b Press MODE button again ("date" starts flashing).
Press SET button to set the correct date.
c Press MODE button again ("hour" starts flashing).
Press SET button to set the correct hour in 12-hour for-
mat. The time is being displayed in 12-hour format,
which means a time from 13:00 onwards is being is
displayed as 01 :00.
p
d Press MODE button again ("minute" starts flashing).
Press SET button to set the correct minute (0,1,2,3,... 59).
e Press MODE button again to switch to normal time.
(date, month, hour and minute appear on the display).
14