Dometic TEC29 Montageanleitung Seite 40

Installation
You can secure the generator with the holders supplied in two ways:
 External installation (fig. 2, page 2):
External installation has the following benefits: lower space requirement,
fast installation, easy access for maintenance work.
– To ensure the generator is attached securely, use the retaining brack-
et (fig. 2 1, page 2) supplied.
– If the air intake opening of the generator is located behind a vehicle
wheel, you need to prevent the wheel from splashing any water into
the generator interior when it rains (e.g. by using a splash guard).
 Internal installation (fig. 3, page 3):
For internal installation, you need to prepare a sealed compartment
against the vehicle interior which can also be insulated against sound.
– Attach exhaust and air intake openings to the floor and in front of the
generator cover. The air intake openings must have cross-section of
at least 240 cm
– You must also fit a seal made of fire-retardant rubber with a thickness
of at least 5 mm between the floor of the vehicle and the generator
(see "Accessories" on page 37).
 Leave a space of at least 20 mm between the generator hood and sur-
rounding parts so that sufficient space remains for cooling air to pass
through.
9.3 Securing the silencer
Observe the following instructions when installing the exhaust pipe:
 Do not create any sharp bends which will inhibit the flow of exhaust
fumes.
 Align the manifold (fig. 4 1, page 3) along the housing to ensure greater
damping of vibration.
 Use the exhaust pipe extension to divert the exhaust fumes (fig. 4 2,
page 3) (see "Accessories" on page 37).
Secure the extension to the vehicle floor (fig. 4 3, page 3).
➤ Secure the silencer (fig. 4 4, page 3) as in one of the alternatives shown
in fig. 5, page 3 to fig. 9, page 5.
40
2
.
TEC29, TEC29LPG
EN