Technical Data; Before Starting The Equipment - EINHELL BG-CS 85 E Originalbetriebsanleitung

Anleitung_BG_CS_85_E_SPK1:_
GB

5. Technical data

Rated voltage:
Power input:
Idle speed:
Adjustment angle:
Grinding wheel Ø (inside):
Grinding wheel Ø (outside):
Grinding wheel thickness:
Totally insulated:
Weight:
Load factor:
A load factor of S2 20 min (intermittent periodic duty)
means that you may operate the motor continuously
at its nominal power level (85 W) for no longer than
the time stipulated on the specifications label (20
minutes ON period). If you fail to observe this time
limit the motor will overheat. During the OFF period
the motor will cool again to its starting temperature.
Sound and vibration
Sound and vibration values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three directions)
determined in accordance with EN 61029.
Grinding
Vibration emission value a = 2,69 m/s
h
K uncertainty = 1,5 m/s 2
Warning!
The specified vibration value was established in
accordance with a standardized testing method. It
may change according to how the electric equipment
is used and may exceed the specified value in
exceptional circumstances.
The specified vibration value can be used to compare
the equipment with other electric power tools.
12
02.05.2011 7:45 Uhr
The specified vibration value can be used for initial
assessment of a harmful effect.
230V 50Hz
~
Keep the noise emissions and vibrations to a
S2 20 min 85 watts
minimum.
-1
4800 min Only use appliances which are in perfect working
order.
35º to the left and right
Service and clean the appliance regularly.
23mm
Adapt your working style to suit the appliance.
max. 108mm
Do not overload the appliance.
3.2 mm Have the appliance serviced whenever
necessary.
II / ®
Switch the appliance off when it is not in use.
2.15 kg
Wear protective gloves.
Residual risks
Even if you use this electric power tool in
accordance with instructions, certain residual
risks cannot be rules out. The following hazards
may arise in connection with the equipment's
construction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.

6. Before starting the equipment

Before you connect the equipment to the mains
80 dB(A)
supply make sure that the data on the rating plate
are identical to the mains data.
3 dB
93 dB(A)
Always pull out the power plug before making
3 dB
adjustments to the equipment.
Assembly (Fig. 3-6)
Place the chain clamping mechanism in the
chuck (Fig. 3) and screw from underneath using
the star screw (Fig. 4)
Before starting the chain sharpener, fasten it
securely to a suitable surface (e.g. a workbench)
at a suitable place (protected against dust, dry,
2
well-lit) using M8 fixing screws and washers (Fig.
5)
Make sure when doing so that the mounting
plate of the chain sharpener is pushed onto the
surface as far as it will go (Fig. 6)
Seite 12