3M Peltor WS Alert XP Bedienungsanleitung Seite 9

GB
3M Peltor WS Alert XP
™ ™ ™
This product has been tested and approved against the personal protection equipment (PPE) directive 89/686/EEC, and is also in
compliance with the R&TTE directive 1999/5/EC for CE marking. Read these instructions carefully before use and save for future
reference.
1. WHAT IS WHAT
(A:1) Headband wire (Stainless steel)
(A:2) Two-point fastener (Acetal)
(A:3) Ear cushion (PVC foil and Polyester foam)
(A:4) Microphone for surround sound
(A:5) Attenuation cushion (Polyurethane foam)
(A:6) Inner shell
(A:7) Outer shell
(A:8) Clamp
(A:9) Headband (PVC foil)
A:10) Headband padding
(A:11) AUX audio input, 3.5 mm stereo
(A:12) Speech mic input, J22
(A:13) Charger jack
(A:14) On/Off/Mode
(A:15) VOL+,
(A:16) VOL –
(A:17) Menu
(A:18) Bluetooth/PTT
(A:19) Speech microphone
(A:20) Non rechargeable AA alkaline batteries
2. FITTING AND ADJUSTMENT
IMPORTANT! For the best protection, brush aside hair around the ears so the ear cushions fit snugly against the head. Spectacle
frames should be as thin as possible and fit close to the head to minimise acoustic leakage.
Headband:
(B:1) Slide out the shells. Tilt the upper part of the shell outwards to ensure the wires are positioned away from the headband.
(B:2) Adjust the height of the shells by sliding them up or down whilst holding the headband in place.
(B:3) The headband should be positioned across the top of the head.
Helmet attachment:
(B:4) Insert the helmet attachment in the slot on the helmet and snap it into place. To switch the unit fromventilation to working
mode, press the headband wires inwards until you hear a click on both sides. Ensure that the shell and the headband wires in
working mode do not press on the edge of the helmet so that noise leakage can occur.
Note: The shells can be set in two positions: (B:5) working mode and (B:6) ventilation mode.
3. USAGE/FUNCTIONS
3:1 Inserting included batteries
Remove the left outer shell.
(C:1) Insert a blunt tool or finger under the edge of the clamp and pull outwards 3–4 mm.
(C:2) Press/slide the clamp down. Remove the shell.
Insert the non-rechargeable AA alkaline batteries included with the product.
Ensure that the poles are correctly aligned.
Warning! Do NOT try to charge the included alkaline batteries as this may damage the headset.
The headset can also operate on rechargeable NiMH batteries , see (3:2)
Low battery level is indicated by a voice message: "low battery".
2