Safety Instructions; Essential Information - Bosch TPA 200 Originalbetriebsanleitung

en 22 | TPA 200 | Operation
5. Operation
5.1

Safety instructions

DANGER - Risk of injury or crushing
with vehicles, which are not secured
against rolling away.
Vehicles not secured against rolling
away pose a risk, e.g. of being trapped
against a workbench.
¶
Secure the vehicle during the test to
prevent it from rolling away.
¶
Put automatic gearboxes in park
position and manual gearboxes in
neutral, then pull on the handbrake
or block the wheels with vehicle
stop blocks (wedges).
5.2 Main Menu
After the TPA 200 has been switched on, several
menu items are available:
Menu item Description
Check
This function enables you to test the
sensors in the tire.
The test gives the tire inflation pres-
sure, the condition of the battery and
the sensor number (ID).
Prog. Sensors This function enables you to program
sensors. This function is for example
required, if a faulty sensor is being re-
placed with a new sensor, or if win-
ter tires are being changed to sum-
mer tires.
Repair This function enables you to per-
form a test of the sensors again af-
ter a repair.
Send All Data
The data, which has been saved by
the TPA 200, can be transferred via
Bluetooth to the "TPA Startcenter"
software.
Settings This function enables you to acti-
vate all device settings, e.g. menu
language, operation sequence, Blue-
tooth. The software of the TPA 200
can also be updated via this function.
Off
This function switches off the
TPA 200.
|
1 689 989 200 2014-05-08
5.3

Essential information

Before performing the menu items "Check",
"Prog. Sensors" or "Repair", set the desired
operation sequence in the menu item "Settings
>> General >> Workflow.
Operation sequence
i
Depending on the operation sequence select-
ed, different vehicle data is transferred to the
"TPA Startcenter", and the test sequences
change accordingly.
Four operation sequences can be selected:
Operation Description
sequence
Job code We recommend this as the standard
setting for workshops, where the
TPA 200 is used frequently.
R A vehicle code is automatically as-
signed at the end of the "Check".
R In the case of the "Repair", a job
order number can be entered after
the vehicle identification.
Registration
In the case of the "Check" or "Repair",
the license number can be entered af-
ter the vehicle identification.
Model Year We recommend this as the standard
setting for appointed dealer work-
shops, where the TPA 200 is used fre-
quently on the same vehicle makes
and vehicle models.
The model and year of manufacture
are automatically saved at the end of
the "Check" or "Repair".
None The vehicle must always be identi-
fied. Saved vehicles are not available
for selection.
Robert Bosch GmbH