Starting The Engine - Reely SEA Aqua Passion Bedienungsanleitung

d) Starting the Engine
General information on combustion engines
At commissioning of the new engine, a certain run-in time must be complied with. During this time, engine
parts are tuned to one another, whereby maximal capacity is reached and premature wear is prevented.
Running in therefore needs to be performed very carefully!
Attention!
Since the model boat has no centrifugal force clutch, the ship propeller turns once the motor is running. The
ship propeller is very sharp-edged and may cause injury and/or property damage when handling, replacing
and in operation!
Starting the engine cold
The carburettor has an integrated diaphragm pump that activates when the engine is running.
It uses the alternating over- and underpressure in the crankshaft housing to transport fuel into the carburettor.
For starting, the carburettor has a manual pump that is used to transport fuel into the carburettor. This manual pump
comprises a transparent rubber sphere (figure 5, item 3), which serves as sight glass for visual inspection of fuel
supply to the carburettor at the same time.
• Connect the choke flap with the choke lever (2)
by twisting the lever in a 90° angle.
• Actuate the manual pump (push rubber sphere
several times) until the „gauge glass" is completely
filled up with fuel and the latter reaches the
carburettor.
• Now pull the cable pull starter (4) through
repeatedly until you can hear the first ignition of
the engine.
• Then open the choke flap again at once (turn lever
back by 90°) and pull the rope pull starter quickly
until the engine starts up. Hold the model well
during this.
Attention!
Do not pull out the cable starter all the way but only to a maximum of 3/4 of its length! Determine the rope
length by slow extension without ignition! Never pull out the cable pull starter with force!
• When the motor goes out again right after the first start-up, close the chock flap and pull the cable pull starter through
again until the motor runs again.
• Once the motor is running, release the cable pull starter and set the throttle/brake lever at the remote control transmitter
to the idle position.
34
Figure 5